Arduino meets "The Frog-Prince"

Since the mouth of the frog is slightly too small, I need to take out a bit more of inside of the frog. I cut out a small slot in the inside of the mouth and then I can pull out a little of the content.

It seems to be a little more difficult to get everything at the right position. The eyes (LEDs) obviously need to be there were the eyes of the frog are already. I cut two holes from the back of the eyes to get the cables of the LEDs get through the fabric. It seems quite hard, but once their are inside, they do not move and fit properly.

On the arduino board and the blackboard I am using, I tight up all wires as short as they can possibly be. By doing this, I hopefully avoid that wires loosen when I enter everything into the frog's mouth.

By now I also know the name of the project. "The Frog-Prince".